Table of Contents
Advertisement
Mounting with split seals
Mounting and greasing
the bearings
Mounting the lower halves
(Split) bearing
Lower seal halves
Mounting the lower halves
the mounting procedure
Schaeffler Technologies
Mount the bearing in accordance with the bearing mounting
instructions. We recommend using a split bearing.
For Schaeffler split spherical roller bearings:
MON 90, Mounting instructions for FAG split spherical roller
bearings lubricated with grease and plummer block housings,
https://www.schaeffler.de/std/1F91
In housings closed on one side, insert one seal into one annular slot
of the seals
only and leave the other annular slot free for the cover.
Unpack and dismantle the seals.
Introduce grease into the annular slots in the lower housing
section.
For double lip seals, see also section Inserting the lower halves
of double lip seals EDH, page 12:
Fill the area between the two seal lips in each seal half with
grease. Insert one seal half into each of the annular slots
in the lower housing section.
For felt seals, see also section Inserting the lower halves
of felt seals EFS, page 16:
Press the oil-soaked felt strips into the slots in the adapter
halves. Insert the halves of the O ring into the two annular slots
in the lower housing section. Insert the adapter halves with
the felt strips into the two annular slots.
Lower the shaft or raise the lower housing section until the
bearing is repositioned in the lower housing section.
3
Annular slots
Shaft
Figure 29
of the seals
Completing
Continue mounting the upper housing section, see instructions
from section Greasing the upper housing section, page 14.
1
2
4
MON 92
27
Advertisement
Table of Contents
