Table of Contents
Advertisement
Mounting housings
with split seals
with double lip seals EDH
Locating and greasing
the lower housing section
Lower housing section
Foot screws with support washers
Locating surface
Area for grease
(in bearing position)
Locating and greasing
the lower housing section
Schaeffler Technologies
The procedure for mounting housings with split seals is described
using the example of double lip seals EDH. If individual mounting
procedures deviate from this for other seal types (EFS), only these
special features are shown below.
Mounting
WARNING
Rupture of the eye bolt in case of overload. Severe personal injury
or damage to property possible as a result of falling housing.
Aways screw the eye bolt fully into the upper housing section.
Only lift the housing and bearing with the eye bolt.
Place the lower housing section in the correct mounting position
on the locating surface. The complete housing can first be set
down and the upper housing section can then be lifted off again.
Insert the foot screws with one support washer each in the lower
housing section and tighten until finger tight.
Introduce a portion of the grease to be used for initial greasing
into the lower housing section on both sides of the ultimate
bearing position.
Grease quantity for initial greasing, see page 35.
Annular slot
Figure 5
9
1
5
8
4
MON 92
11
Advertisement
Table of Contents
