Special Features Of Felt Seals Efs - Schaeffler SES Series Mounting Manual

Special features
of felt seals EFS
Inserting the lower halves
of felt seals EFS
Lower housing section
Inserting the lower halves
of the felt seals
Inserting the upper halves
of felt seals EFS
Upper housing section
Adapter with felt strip
Inserting the upper halves
of the felt seals
16 MON 92
Split plummer block housings SES
The procedure for mounting housings with split seals is described
using the example of double lip seals EDH. Only individual deviating
mounting procedures for felt sealing rings EFS are shown below.

Follow the mounting instructions for double lip seals EDH,
page 11, and note the deviations from the mounting procedure
for felt ring seals EFS.
In housings closed on one side, insert one seal into one annular slot
only and leave the other annular slot free for the cover.

Ensure that all felt strips are soaked with oil.

Press the oil-soaked felt strips into the slots in the adapter
halves.

Insert the halves of the O ring into the two annular slots
in the lower housing section.

Insert the adapter halves with the felt strips into the two annular
slots.
Felt strip
5
Adapter
O ring
Annular slot
Figure 13

The lower halves of the felt seals are mounted.

Continue with section Mounting and greasing the bearings,
page 12.

Insert the O rings and the adapters with the felt strips into the
two annular slots in the upper housing section. In housings
closed on one side, insert these into one annular slot only and
leave the other annular slot free for the cover.
O ring
Annular slot
8
Figure 14

The upper halves of the felt seals are mounted.

Continue with section Mounting the upper housing section,
page 15.
5
6
2
5
6
8
7
1
2
6
7
7
6
Schaeffler Technologies