Table of Contents
Advertisement
Tightening torques
for connecting screws
Tightening torques
for connecting screws
Additional holes
for foot screws and pins
Additional holes
for foot screws and pins
Schaeffler Technologies
Connecting screws are used for screw mounting the upper housing
section to the lower housing section. They are included in the scope
of delivery of the housing.
Screws to DIN EN ISO 4014
Material 8.8
M10
M12
M16
M20
M24
Split plummer housings SES are generally fixed in place using
two foot screws. The housing base has two extended slots for this
purpose, to enable good alignment during assembly.
For location on T profiles, four foot screws are required. The points
for additional holes are marked by cast-in pilot holes, Figure 31 and
table, page 34.
Further markings indicate the locations at which holes can be pro-
duced for pins to secure the position, Figure 31 and table, page 34.
n
2
Figure 31
Recommended tightening torque
Nm
51
87
215
430
740
s
2
u
2
m
1
m
2
n
1
u
1
MON 92
33
Advertisement
Table of Contents
