Table of Contents
Advertisement
65ME/65ME+
IDE HDD Block Mode Block mode is also called block transfer, multiple
Power ON FunctionThis option allows you to select <KB Power ON
KB Power ON Pass-
Hot-Key Power ON Boot up the system via predetermined keyboard hot
Onboard FDC
Controller
Onboard Serial
Port 1 / Port2
UART Mode SelectThis item allows you to select UART mode.
UR2 Duplex ModeThis item allows you to select the IR half/full duplex
Onboard Parallel PortThis item allows you to determine onboard parallel
58
commands, or multiple sector read/write. If your IDE
hard drive supports block mode (most new drives do),
select Enabled for automatic detection of the optimal
number of block read/write per sector the drive can
support.
The choice: Enabled, Disabled.
Password> , <Hot-Key Power ON> or others.
The choice:Any Key,Button only,Keyboard 98,
Password,Hot-Key,Mouse Move,Mouse Click.
When user sets a password for keyboard,the pass-
word user set that return the system to Full On state.
word
key.
The choice:<Ctrl>+<F1>...<F12>
Select Enabled if your system has a floppy drive con-
troller (FDC) installed on the system board and you
want to use it. If you install add-in FDC or the system
has no floppy drive, select Disabled in this field.
The choice: Enabled, Disabled.
Select an address and corresponding interrupt for the
first and second serial ports.
The choice:3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/
The choice:Normal,IrDA,ASKIR,SCR.
function.
The choice:Full,Half.
port controller I/O address setting.
The choice: 378H/IRQ7, 278H/IRQ5, 3BC/IRQ7,
IRQ3, Disabled, Auto.
Disabled.
Advertisement
Table of Contents
