Table of Contents
Advertisement
65ME / 65ME+
JBAT1/JBAT2: CLEAR CMOS DATA
Clear CMOS Data
Retain Data (default)
A battery must be used to retain the motherboard configuration in CMOS RAM.
NOTE : You can clear CMOS by shorting 2-3 pin when the system is POWER
OFF. Then, return to 1-2 pin position (default). It may damage the
motherboard if clearing the CMOS in POWER ON status. Unplug the
power cord from power supply before clearing CMOS will be a best bet
for user.
JWOL1 : WAKE ON LAN (WOL) FUNCTION
Connect the Wake On LAN signal from LAN card
to JWOL1
This connector connects to a LAN card with a Wake On LAN output. The connector
powers up the system when a wake-up packet or signal is received through the
LAN card.
This feature requires that Wake On LAN feature is enabled at the BIOS "Power
Management Setup" and that your system has an ATX power supply with at least
720mA / +5V
CD_IN1/CD_IN2: CD-ROM AUDIO CONNECTOR
PIN NO.
PIN 1
PIN 2
PIN 3
PIN 4
TAD1 / TV1 CONNECTOR
PIN NO.
PIN 1
PIN 2
PIN 3
PIN 4
TAD1
: Telephone Answering Device / Modem connector.
Connects a voice modem to transmit and receive audio signals.
TV1
: TV Tuner connector.
Connects a TV card or second CD-ROM drive.
TAD1 / TV1 is only for
20
standby power.
CD_IN1
GND
Left Channel
GND
Right Channel
TAD1
PHONE
GND
GND
TADOUT
65ME+
1
3
JBAT1
JBAT2
1
3
1
3
JBAT1
JBAT2
1
3
JWOL1
CD_IN2
Left Channel
GND
GND
Right Channel
TV1
TV_L CHANNEL
GND
GND
TV_R CHANNEL
Advertisement
Table of Contents
