Disassembly; Disassembling The Product; Removing The Handle From The Handpiece (Optional) - Storz DRILLCUT-X II Instructions For Use Manual

7 Disassembly

7.1 Disassembling the product

1. Pull back and hold the shaver handpiece lock.
2. Remove the shaver attachment or sinus burr from the instrument holder on the
DRILLCUT-X II/DRILLCUT-X II-35 and release the lock again.
3. Remove the suction tube from the suction port on the DRILLCUT-X II/DRILLCUT-X II-35.
4. Remove the irrigation tube from the irrigation port of the DRILLCUT-X II/DRILLCUT-
X II-35.
5. Pull the inner sheath of the shaver attachment or the sinus burr out of the outer sheath in
a proximal direction.

7.2 Removing the handle from the handpiece (optional)

1. Loosen the rotating wheel on the handle by turning the rotating wheel counterclockwise.
Instructions for use • DRILLCUT-X II/DRILLCUT-X II-35 • WWK497_EN_V1.0_03-2020_IFU_CE-MDR
Disassembly
26