Fluke 6080A Service Manual page 30

INTRODUCTION AND SPECIFICATIONS
SWEEP FUNCTIONS
DATA ENTRY PARAMETERS
SWEEP SPEED
SWEEP OUTPUT
PENLIFT
DIGITAL AMPLITUDE SWEEP
SWEEP MODES
SWEEP FUNCTIONS
DATA ENTRY PARAMETERS
SWEEP SPEED
SWEEP OUTPUT
PENLIFT
GENERAL
TEMPERATURE
Operating
Non-Operating
HUMIDITY RANGE
Operating
ALTITUDE
Operating
VIBRATION
Non-Operating
SHOCK
Non-Operating
1-16
Table 1-4. Typical Signal Generator Performance (cont)
Symmetrical sweep, Asymmetrical sweep, Sweep
speed
Sweep width and sweep increment
Minimum 40 ms per increment selectable as (mini-
mum + dwell time) where dwell time can be 0, 20, 50,
100, 200, or 500 ms at each increment.
0 to +10 (± 10%) V. Up to 4096 points in a stepped
ramp. Load > 2 kΩ.
TTL, high for retrace. Load > 2 kΩ.
Auto, single, or manual Linear (Volts) or Log (dB)
Symmetrical sweep, Asymmetrical sweep, Sweep
speed
Sweep width and sweep increment
Minimum 30 ms per increment selectable as (mini-
mum + dwell time) where dwell time can be 0, 20, 50,
100, 200, or 500 ms at each increment.
0 to +10 (± 10%) V. Up to 4096 points in a stepped
ramp. Load > 2 kΩ.
TTL, high for retrace. Load > 2 kΩ.
0 to +50°C (+32 to +122°F).
-40 to +75°C (-40 to +167°F).
95% to +30°C, 75% to +40 °C, and 45% to +50°C.
Up to 10,000 ft.
5 to 15 Hz at 0.06 inch, 15 to 25 Hz at 0.04 inch, and
25 to 55 Hz at 0.02 inch, double amplitude (DA).
Per MIL T 28800D Class 5, Style E.