Positioning Data Editing Mode - Savch SDA2 Series User Manual

3.6 Positioning Data Editing Mode

In positioning data editing mode, it can edit the positioning status, stop position, rotation speed, stop timing,
M code, acceleration time and deceleration time
Po-01
Pd_1: Positioning status
Set all the information regarding the positioning data.
The 4
Display Command mode
A
i
Pd_2: Stop position
Specify the stop position of the motor. The setting value is within the range from -2,000,000,000 to
2,000,000,000 per 1 calibration
Set the stop position of the servo motor when the command mode is ABS; Set the incremental value
when the command mode is INC.
Pd_3: Rotation speed
Specify the moving speed to motor stop position.
The setting value can be determined by the motor shaft within the range from 0.01 to 3,000.00 [r/min]
per 0.01 calibration
Setting speed is not the moving speed of the machine.
[SET] [SET]
no.01
[MENU]
[MENU]
∧/∨
no.15
A.00．0
th
bit The 2
Display
ABS 00
.0
INC co
cE
[SET]
Pd_1 A.00．0
[MENU]
∧/∨
Pd_7
nd rd
~3 bit
Step mode Display
No assigned 0
Continue 1
Cycle end 2
43
st
The 1 bit
M code setting
Disabled
Output at Startup
Output at the end