Datakom D-100 MK2 User Manual page 5

D-100 MK2 User Manual
 Electrical equipment should be installed only by qualified
specialist. No responsibility is assured by the manufacturer or
any of its subsidiaries for any consequences resulting from the
non-compliance to these instructions.
 Check the unit for cracks and damages due to transportation. Do
not install damaged equipment.
 Do not open the unit. There are no serviceable parts inside.
 Fuses must be connected to the power supply and phase voltage
inputs, in close proximity of the unit.
 Fuses must be of fast type (FF) with a maximum rating of 6A.
 Disconnect all power before working on equipment.
 When the unit is connected to the network do not touch
terminals.
 Short circuit terminals of unused current transformers.
 Any electrical parameter applied to the device must be in the
range specified in the user manual. Although the unit is designed
with a wide safety margin, over-range parameters may reduce
lifetime, alter operational precision or even damage the unit.

Do not try to clean the device with solvent or the like. Only clean
with a dump cloth.
 Verify correct terminal connections before applying power.
 Only for front panel mounting.
K96D01-EN
Failure to follow below instructions
will result in death or serious injury
Current Transformers must be used for current measurement.
No direct connection allowed
SAFETY NOTICE
.
- 5 -
Firmware V-6.3