Transferring Logo Data - TOSHIBA TEC Corporation 9000N-FFB Series Owner's Manual

11. PROGRAMMING PROCEDURES

11.17 TRANSFERRING LOGO DATA

Logo data is created on a PC and stored into RAM through the CMT interface. Two different
sizes of logos, 320x118 dots and 256x64 dots, are available on the SL-9000 series. 64KB of
RAM area is secured for logo data, in which the maximum of 13 logos (320x118 dots) or 26 logos
(256x64 dots) can be stored. Before starting the following operation, set the initial setting #10-7
to 1.
NOTE: Two sizes of logos are printed differently as follows:
320x118-dot size logo
256x64-dot size logo
Table 6: Error message during data transmission
Error message
TIME OUT ERROR
DATA ERROR
Get user manuals: See SafeManuals.com
Menu Group: 2
Item No.: 8
<MENU> Load the tape into
8
Group 2
the CMT Loader
ENTER
<Label>
The logo is printed at the lower
center of the print area.
: Print area for logo
Timeout
Incorrect segment
Incorrect logo size
Incorrect number of logos
Incorrect logo number
Incorrect number of dots to be printed.
Parity error
Framing error
Overrun error
Select a transmission item.
1: SAVE(SL-9000
2:VERIFY(SL-9000=CMT)
3:LOAD(SL-9000
<MENU>
PROG.
Group 2
Main
ESC.
<MENU>
<Receipt>
A whole Logo #1 and a half of
logo #2 area printed.
Cause
11-27
11.17 TRANSFERRING LOGO DATA
CMT)
CMT)
: Logo
Error position
Header text Data text