Installation Procedure - TOSHIBA TEC Corporation 9000N-FFB Series Owner's Manual

7. INSTALLATION PROCEDURE

7. INSTALLATION PROCEDURE
Remote Display
Be sure to cover the connectors with the connector cover because of high voltage and
current. If the connectors are exposed to water, a leakage may result.
CAUTION: Never place the scale upside down. Doing so will cause a malfusction.
1. To install the remote display, insert the two screws on the bottom of the remote pipe into
2. Connect the connectors, pull down the connector cover, and install the remote blind plate.
3. Remove the tape from the remote packing and remote cap and lower to fit them to the
Remote Display
Remote Pipe
Remote Cap
Remote Packing
Get user manuals: See SafeManuals.com
the holes provided on the scale base.
Then tighten the screws to secure the remote display.
scale.
Tape
WARNING!
Screw
Hole
Screw
Connector Cover
7-1
7. INSTALLATION PROCEDURE
Remote Blind Plate
Connector
Connector