Table of Contents
Advertisement
11. PROGRAMMING PROCEDURES
11.10 PRINT FORMAT
The SL-9000 can memorize 5 different print formats. After print formats are set, you can call
them by entering the print format number.
<MENU>
Group 2
CHANGE
PLU
Select the Item for adjustment.
1 gradation
= 0.154mm (1 dot)
1 gradation
= 0.462mm (3 dots)
1 gradation
= 0.462mm (3 dots)
Only when using the bar code
change label with pre-feed area.
(This adjustment cannot be made
for the Variable Length Label.)
NOTES:
1. When a commodity name position is adjusted, an address position will move automatically.
2. When entering the other label format #, fine adjust values are initialized.
3. Selecting label format numbers other than those provided in Table 2 results in an error.
4. When selecting a variable length label format, rectangles are printed instead of print items
when test printing.
5. Pressing the
6. Be sure to press the SET NEXT key when a label format for batch printing with backing paper
is selected.
Get user manuals:
See SafeManuals.com
Menu Group: 2
Item No.:
0
Select the print format # which
0
allocates the label format #
by the
NEXT PLU
On-demand
Issue method
Select "SENSIBILITY ADJUST"
Batch
by pressing the
When Batch Printing with backing paper is
selected, the sensitivity of the label sensor will
be set by pressing the
issuing label.
Enter the correct label feed
value.
(Range: 0~199)
Enter the correct value for
commodity name position.
(Range: 0~9)
Enter the correct value for
address position.
(Range: 0~15)
Enter the correct value for
pre-feed area.
(Range:
key allows you to select a print format number from 1 to 5.
–
key or
key.
SET
key.
NEXT
SET NEXT
key before
0~65)
11-16
11.10 PRINT FORMAT
Enter the label format #.
(Refer to Table 2)
j
Is print
FEED
TEST
position
correct?
Incorrect
j
ENTER
<MENU>
Group 2
j
ENTER
Main
j
ENTER
<MENU>
j
ENTER
Correct
CHANGE
PLU
PROG.
ESC.
Advertisement
Table of Contents
