Ad-Hoc Mode - Wiznet WizFi630 User Manual

2.2.5. Ad-hoc Mode

© Copyright 2012 WIZnet Co., Ltd. All rights reserved.
Downloaded from Elcodis.com electronic components distributor
Settings for ad-hoc mode are almost the same as settings for Client (Station) Mode as previously
shown.
The difference with Client mode is that Client mode is used to connect AP.
Client Mode connects to AP, whereas ad-hoc Mode connects with stations that use the same SSID.
Both 1:1 connection and 1:N connection are possible
In case of 1:N, N is possible up to 255
Menu Detailed Menu
WAN
LAN
DHCP Clients
Internet
Setting VPN Config
Routing
Qos(802.1p)
Profile
Link Status
Site Survey
Wireless
Packet Statistics
Setting
Advance
QoS
WPS
Serial Serial Port #1
Setting
Serial Port #2
DMZ
Port Forwarding
Firewall Packet Filtering
Contents Filtering
System Security
System Mgmt
Firmware Mgmt
Config Mgmt
Managements
Port Mgmt
Packet Statistics
System Status
Description ( Link )
Internet connection setting
Local network setting
DHCP Client Information
VPN setting
Static Routing Setting
QoS(802.1p) Setting
Profile
Link Status
Site Survey
AP Wireless Statistics ( Client Mode )
Advanced Wireless Settings(Client Mode)
Station QoS/DLS(Direct Link Setup) Configurations
WPS Settings ( Client Mode )
Serial to LAN(Wired and Wireless)
DMZ
Port forwarding
Packet filtering
Contents filtering
System Security
System Management
Firmware
Config Settings
Port Setting
Packet Statistics
System Status
List Number
2.3.1
2.3.2
2.3.3
2.3.4
2.3.5
2.3.6
2.4.9
2.4.10
2.4.11
2.4.7.2
2.4.2.2
2.4.8
2.4.5.2
2.5
2.6.1
2.6.2
2.6.3
2.6.4
2.6.5
2.7.1
2.7.2
2.7.3
2.7.4
2.7.5
2.7.6
21