Verifying The Ip Settings; Configuring For Pull Printing - Lexmark T630 Setup Manual

Verifying the
IP settings
Note:
To reach a command
prompt on Windows
computers, click Start
Programs Command
prompt (or Accessories
Command prompt if using
Windows 2000).
Configuring for
Pull Printing
8
Repeat step 6 to set the IP Netmask.
9
Press Menu until you see Set IP Gateway, and then press
Select.
10
Repeat step 6 to set the IP Gateway.
11
When you are finished, press Go to return the printer to the
Ready state.
12
Go to "Verifying the IP settings" on page 57.
1
Print another network setup page. Look under the "TCP/IP"
heading and make sure the IP address, netmask, and gateway
are what you expected.
See "Printing a network setup page" on page 54 if you need
help.
2
Ping the printer and verify that it responds. For example, at a
command prompt on a network computer, type ping followed
by the new printer IP address (for example):
ping 192.168.0.11
If the printer is active on the network, you receive a reply.
If your printer has an optional ImageQuick firmware card installed, you
can configure for Pull Printing once an IP address has been assigned
to the printer.
For detailed configuration instructions, refer to the CD that shipped
with the ImageQuick firmware card.
Configure for TCP/IP
57