Verifying The Ip Settings - Lexmark Optra T522 Setup Manual

Pull Printing (ImageQuick)
24
Verifying the
IP settings
Configure for
6
Change the address by pressing Menu to increase
(or decrease) each number. Press Select to move
to the next segment. Press Select when you are
finished.
The message Saved appears briefly.
7
Press Menu until you see Set IP Netmask, and then
press Select.
8
Repeat step 6 to set the IP Netmask.
9
Press Menu until you see Set IP Gateway, and then
press Select.
10
Repeat step 6 to set the IP Gateway.
11
When you are finished, press Go to return the
printer to the Ready state.
1
Print another network setup page and make sure
the IP Address, Netmask, and Gateway are what
you expected.
Use the information in "Printing a network setup
page" on page 21 if you need help.
2
Ping the printer and verify that it responds.
For example, at a command prompt on a network
computer type "ping" followed by the new printer IP
address:
ping xxx.xxx.xxx.xx
If the printer is active on the network, you will
receive a reply.
If your printer has an optional ImageQuick™ firmware card
installed, you can configure for Pull Printing once an IP
address has been assigned to your printer.
For detailed configuration instructions, refer to the online
documentation on the ImageQuick CD. The ImageQuick
CD is shipped with printers that have the optional
ImageQuick firmware card preinstalled, and also with the
firmware card if you purchased it separately.