Volvo Penta D4 Operator's Manual page 25

2
5
P0003714
1
4
P0002048
7748934 04-2008
1
3
4 6
Trim Controls
The drive can be trimmed with the Power Trim panel
or with the button on the trim control. On twininstalla-
tions there is a control for each drive. The Power Trim
panel is used for both single and twin engine installa-
tions. For twin engine installations, the control panel
can be used to make individual or simultaneous adjust-
ments to the drives.
The current position of the drive is shown on the trim
instrument. By trimming out the drive away from the
transom, the bow will be "raised" in relation to the hor-
izontal axis and trimming in the drive will "lower" the
bow of the boat
Trimming out the drive
Press button 1 on the control panel to raise the bow of
the boat – the drive is trimmed out.
Twin installation: In twin engine installations, both
drives can be operated simultaneously by pressing
button 1.
To operate the drives separately press button 2 on the
control panel for the port drive and button 3 for the
starboard drive.
The drive's position is shown on the trim instrument.
Trimming in the drive
Press button 4 on the control panel to lower the bow of
the boat — the drive is trimmed in.
Twin installations: In twin engine installations, both
drives can be operated simultaneously by pressing
button 4.
To operate the drives separately press button 5 on the
control panel for the port drive and button 6 for the
starboard drive.
The drive's position is shown on the trim instrument.
Emergency trimming
If a fault occurs which prevents the drive from being
trimmed, it is possible to perform an emergency trim-
ming, please refer to In Case of Emer-
gency page 57.
Instruments and Controls
23