Volvo Penta D4 Operator's Manual page 16

Instruments and Controls
P0002383
1 2
P0002382
14
G H
3 4 5
EVC System Display
In the EVC system display it is possible to show mul-
tiple windows with different information. There are four
display modes which can be chosen using the buttons
on the instrument.
Button 1–4 shows the different display modes. Button
5 i used to adjust the contrast and to access the con-
figuration menu, please refer to section Configuration
menu.
The EVC menu can be shown in the display by entering
System information, refer to section Multi, button 2, or
the Configuration menu. In this mode the display works
the same way as the display in the tachometer and is
handled via the separate control panel, please refer to
section Instruments and Controls page 19.
If no tachometer is installed the EVC meny can be
reached by pressing the knob on the control panel. To
get back to the display modes, press
At start up, the display performs a self-test. If an con-
stant signal is heard, the system has discovered a mal-
function. The display will work but may act in an unex-
pected way.
NOTICE! Only installed functions will be shown in the
display.
Display modes
Press button 1–4 to view the function menu for the
buttons, apperaring in the lower part of the display.
Press button 1–4 to choose the desired display mode.
1 Engine
2 Multi
3 Trip
4 Graph
To leave the menu, wait a few seconds or press button
5 (EXIT).
.
7748934 04-2008