LWRITEFILE Command
Use this command to write data to a file on a storage device.
Syntax:
Notes:
•
The file must be closed using the LCLOSEFILE command once all operations
are complete.
•
The command is ignored if the file doesn't exist on the device. The command
is ignored if the file isn't already open with a write
•
If START =
is assumed.
•
If START =
positions the file pointer at the end of the file.
•
If the LENGTH is omitted from a LWRITEFILE command, an @PJL END
DATA must be placed at the end of the data. All data up to '@' in @PJL END
DATA is written to the file. The command requires either the LENGTH
parameter or the @PJL END DATA be specified, but not both.
LRUNFILE Command
Use this command to load and execute a file on a storage device. For example, use
this command to run the resident demo file or a demo file stored on flash or disk.
Syntax:
3-91
is omitted on a file with an
is greater than file size and the
PJL
.
of
, location
is
, it