Common Variables For Both Printer Languages - Lexmark C752 Technical Reference

Common Variables for Both Printer Languages

Note:
The following common variables are supported for both PCL emulation and PostScript
emulation, unless otherwise noted. Therefore, the [
parameter should not be specified.
To determine which variables your printer supports, see "Table B-1: Common
Variables for Both Printer Languages" on page B-1.
Table 3-3: Common Variables for Both Printer Languages
Variable
AUTOCONT
(DEFAULT only)
BINDING
BITSPERPIXEL
CLEARABLEWARNINGS
(READ only)
COPIES
The word common applies to those variables common to both your printer
and the Hewlett-Packard Company's LaserJet printers.
Function Selections
Auto Continue 0, 5 to 255, OFF, ON
A value of 0 or OFF indicates Auto Continue is
disabled. A value of ON indicates Auto Continue is set
to 30.
INQUIRE or DINQUIRE on the Auto Continue variable
returns a numeric value.
Note: If a value greater than 255 is specified by a SET
or DEFAULT command, the value is changed to 255.
Duplex Bind LONGEDGE, SHORTEDGE
Image 1, 2, 4, Auto
Enhancement
A value of 1 indicates the Image Enhancement
Technology and
Technology setting is set to Off. A value of 2 or 4
Image
indicates the Image Enhancement Technology setting
Enhancement
is set to On.
Technology Type
INQUIRE or DINQUIRE returns the value of Image
Enhancement Technology as follows:
• If Image Enhancement Technology is set to Off, 1 is
returned.
• If Image Enhancement Technology is set to On, 2 or
4 is returned depending on the Image
Enhancement Technology Type setting. If Image
Enhancement Technology Type is set to On, the
numerical value of BITSPERPIXEL is returned. If
Image Enhancement Technology Type is set to
Auto, a value of 2 or 4 is returned depending on the
amount of total memory installed.
Auto Continue JOB, ON
from operator
If Auto Continue is set to On, JOB is returned.
panel non-fatal
If Auto Continue is set to Off, ON is returned.
warning messages
Number of copies 1 to 999
of each page
Note: If a value greater than 999 is specified by a SET
or DEFAULT command, the value is changed to 999.
3-12
Factory Default
0
LONGEDGE
1
ON
1
PJL
]