Table of Contents
Advertisement
7
Operating
7.1 Switching the device on / off
Switching on
Turning off
7.2 Operating mode Automatic
1.
Verify that all required laser safety precautions have been taken. Make sure
that there is no one in the reach of the laser beam.
2.
Connect an external safety switch to the [REMOTE] connection (e.g. an emer‐
gency stop button) or another equivalent device with protection function.
3.
Insert the safety key into the lock.
4.
If not already done, connect the device to the mains.
5.
After a few seconds, the fan and the motors start to work. The display shows
the current version number of the device.
ð The device is operational.
6.
Turn the safety key to the 'ON' position to turn the laser beam on.
1.
Turn the safety key to the 'OFF' position to turn the laser beam off and remove
the key. Keep the safety key under control.
2.
Disconnect the device from the mains.
This setting is only relevant if the device is not controlled via a DMX controller and
not working as slave in a master / slave configuration.
1.
Press [MENU] repeatedly, until the display shows 'Aut' and confirm with
[ENTER].
2.
Press [UP] or [DOWN] to select between automatic programmes
'Au01' ... 'Au14' .
3.
Confirm the selection with [ENTER].
ð The selected automatic programme is played back immediately.
4.
Press [ENTER] again to open the settings menu for the programme run speed.
5.
Press [UP] or [DOWN] to set the programme run speed between 'S 1'
(slow) ... 'S100' (fast).
6.
Confirm the selection with [ENTER].
7.
To return to the main menu without making changes, press [MENU].
All FX Bar
Operating
17
Advertisement
Table of Contents
