Table of Contents
Advertisement
Installation
4
Installation
10
Unpack and check carefully there is no transportation damage before using the unit.
Keep the equipment packaging. To fully protect the product against vibration, dust
and moisture during transportation or storage use the original packaging or your
own packaging material suitable for transport or storage, respectively.
You can install the device standing or hanging. When in use, the device must be
mounted at a solid surface or clamped to an approved truss.
Work from a stable platform whenever you install or move the device or when you
perform any kind of maintenance. Block access under the work area.
DANGER!
Follow the instructions in the chapter titled "Safety Instructions" in the
user manual.
To avoid laser emission, remove the safety key before you start to install
the device.
WARNING!
Stray laser radiation
Inadequately secured additional components may cause stray laser radi‐
ation.
Make sure that all additional components are adequately secured.
WARNING!
Laser radiation – safety switch required
The laser beam must be defeatable any time during operation, to avoid
hazards by faults, unsafe operation conditions, or disturbance within the
audience.
Therefore you have to connect a safety switch (emergency shut off) to
the unit, by which you can switch off the laser any time even from a
remote observation point (e.g. FOH position).
DANGER!
Follow the instructions in the chapter titled "Safety Instructions" in the
user manual.
To avoid laser emission, remove the safety key before you start to install
the device.
LED effect
Advertisement
Table of Contents
