Remote Control Battery Installation; To Replace The Remote Control Batteries - Lexicon MC-4 User Manual

MC-4

REMOTE CONTROL BATTERY INSTALLATION

The remote control requires two AA batteries that should be replaced as needed. Use Alkaline batteries, which last longer without leaking.
When the batteries are low on power, the remote control enters a low-voltage condition that prevents it from operating the MC-4. When
this occurs, follow the instructions below to replace the batteries. Normal operation will resume when new batteries are installed.

To replace the remote control batteries:

1. Locate the battery compartment on the back of the remote control. Then remove the battery compartment cover as shown in Figure A
(bottom-left). To do this, press the tab attached to the cover and pull the cover away from the remote control.
2. Remove old batteries inserted in the compartment (if applicable).
3. Insert two AA batteries in the compartment as shown in Figure B (bottom center). Make sure the batteries are correctly inserted, observing
the proper polarity.
4. When new batteries have been installed, close the battery compartment cover as shown in Figure C (bottom-right). To do this, align the
cover with the guide on the back of the remote control and press the cover until it snaps into place.
5. Dispose of the old batteries (if applicable).
A
B
Getting Started
C
1-5