RUKO F11GIM2 User Manual page 28

F11 G IM 2 User Manual
The Gimbal cannot work during the compass and Gyro calibration.
⑤
Put the aircraft on a level surface after calibration, then the gimbal will
start to work after
Precision elements in the gimbal may be damaged in a collision
or impact , which may cause the gimbal to function abnormally.
Avoid getting dust or sand on the gimbal and the camera,
especially in the gimbal motors.
DO NOT apply extera force to the gimbal after the gimbal is
powered on, as this may cause the gimbal to function
abnormaly or even lead to pemanentmotor damage.
Make sure to install the gimbal cover when the drone is not in
use.
If the gimbal get wet after flying in wet weather, temporary
failure might occur, make the gimbal and the drone dry so as to
get it recover to full function.
26
Copyright ©2022 Ruko All Rights Reserved.
20 seconds.
Before Start
During Compass and Gyro calibration
Put on a level surface and wait for 20 seconds