Other Devices Installation; Expansion Slots Installation - PCchips M925G Series Manual

Other Devices Installation

Floppy Diskette Drive Installation
The motherboard has a floppy diskette drive (FDD) interface and
ships with a diskette drive ribbon cable that supports one or two
floppy diskette drives. You can install a 5.25-inch drive and a 3.5-
inch drive with various capacities. The floppy diskette drive cable
has one type of connector for a 5.25-inch drive and another type of
connector for a 3.5-inch drive.
IDE Devices
Your motherboard has a primary and secondary IDE channel
interface (IDE1 and IDE2). An IDE ribbon cable supporting two
IDE devices is bundled with the motherboard.
If you want to install more than two IDE devices, get a second IDE
cable and you can add two more devices to the secondary IDE
channel.
IDE devices have jumpers or switches to set the IDE device as
one
MASTER or SLAVE. When installing two IDE devices on
cable, ensure that one device is set to MASTER and the other one
to SLAVE.
This motherboard supports Ultra DMA 66/100/133. UDMA is a
technology to accelerate devices' performance in the IDE channel.
To maximize performance, install IDE devices that support UDMA
and use 80-pin IDE cables supporting UDMA 66/100/133.

Expansion Slots Installation

This motherboard has one 4xAGP, one CNR and three 32-bit PCI
(Peripheral Components Interconnect) expansion slots.
4 x AGP (Accelerated Graphics Port) Slot
You can install a graphics adapter supporting 4xAGP specification
in the AGP slot. This slot has one 4xAGP edge connector.
CNR (Communications Networking Riser) Slot
You can install a CNR (the Communications Networking Riser)
card in the CNR slot.
14