PCchips M925G Series Manual page 28

S.M.A.R.T. for Enable this item if any IDE hard disks
Hard Disks support the S.M.A.R.T. (Self-
Monitoring, Analysis and Reporting
Technology) feature.
BootUp Num- This item determines if the Num Lock
Lock key is active or inactive at system start-
up time.
If you have two diskette drives installed
Floppy Drive
Swap and you enable this item, drive A
becomes drive B and drive B becomes
drive A.
Floppy Drive If you enable this item, your system will
Seek check all floppy disk drives at start up.
Disable this item unless you are using an
old 360KB drive.
Password Check If you have entered a password for the
system, use this item to determine, if the
password is required to enter the Setup
Utility (Setup) or required both at start-
up and to enter the Setup Utility
(Always).
Boot to OS/2 > Enable this item if you are booting the
64MB OS/2 operating system and you have
more than 64MB of system memory
installed.
L2 Cache Leave these items enabled since all the
processors that can be installed on this
board have internal L2 cache memory.
If you enable this item, a segment of the
System BIOS
Cacheable system BIOS will be copied to main
memory for faster execution.
DRAM Timing This item allows you to enable or disable
By SPD the DRAM timing defined by the Serial
Presence Detect electrical.
DRAM This item determines frequency of
Frequency DRAM memory.
22