Chapter 3: Install The Disk Shelves In The Rack; Remove Filler Panels; Install An Es40 Shelf Into The Rack; Installing The Rails In The Cabinet - Dell EMC PowerProtect DD6400 System Expansion Manuallines

Table of Contents

Topics:

•

•

Remove filler panels

The front space of the rack into which you will install the shelf is usually covered by a filler panel. If one or more filler panels

cover the space where you want to install the shelf, use this procedure to remove each panel.

Steps

1. On the filler panel, slide the left and right securing tabs to the open position (towards the center of the panel).

2. Remove the filler panel from the cabinet.

Install an ES40 shelf into the rack

Follow the steps in this section to install the rails, ES40 expansion shelf, and bezel. Follow these steps for each ES40 shelf you

are installing.

There are no specific placement requirements for the ES40 shelves in relation to the DD6400 controller in the rack, as long as

they are close enough to be connected by cables no longer than five meters.

NOTE:

The included cables are one meter. Three and five meter cables are optional lengths.

About this task

The rails are compatible with racks with square holes, unthreaded round holes, and threaded round holes.

NOTE:

The front edge of each rail is stamped L or R for left or right side with the rail facing the cabinet front.

Install each rail in the cabinet.

Install the Disk Shelves in the Rack

Table of Contents

Show Quick Links

Table of Contents