Changing Measurement Mode; Directions For Use; Measuring In Body Mode With Distance Control - Microlife FR1DQ1-B User Manual

select year (21~40), then Press "MODE"
○
2. Press "MEMO" 5 button to select month (1~12), then press "MODE"
move to day setting
○
3. Press "MEMO" 5 button to select day (1~31), Press "MODE"
next setting
4. Follow the previously mentioned instructions to set the day, hours, and minutes.
5. Once you have set the minutes and pressed the START/IO button
displayed.

If no button is pressed for 20 seconds, the device will go back to stand-by for measurement with no date/time
information display and then switches to ready for measuring.

Press "Start/IO" button at any time-setting status, will allow to enter measuring stand-by mode directly. (If there is any
item of time-setting have not been completed, they will be show with no-information--)

Setting the beeper
At any status, press "MODE" ○ 6 button for 3 seconds, will enter beep on/off setting
In "beeper on/off" setting mode press and hold the "MODE" button
1.
○
Press the MEMO 5 to either turn the beeper on or off. The beeper is activated when the beeper icon
2.
shown without across. When the beeper setting has been chosen, press the START/IO button
stand-by measurement mode; otherwise, the device automatically switches to ready for measuring after 10
seconds.

6. Changing measurement mode

Press the START/IO button
1.
The default mode is 3S body mode. Press the MODE button
2.
○
object mode 13 .

7. Directions for Use

Always remove the protective cap
Measuring in 3S and 1S body mode with distance control
○
6 button to confirm the years' setting, then move to month setting.
○
26
○ ○
4 . The display 3 is activated to show all segments for 1second.
○
before use.
27
○
6 button to confirm the month setting. then
○
6 button to confirm the day setting. then move to
○
4 , the date and time are set and the time is
○
6 for 3seconds to set the beeper
○
6 to switch between 3S, 1S body mode
○
26 .
○
26 is
○
4 to enter the
○
and
12