Toyota 7FG 10 Repair Manual page 97

If If the standard the standard is is not
ing nut to move the diff ing nut to move the differe
rection. rection.
(1) (1) When When the backlas the backlash h is is exces
Loose Loosen n the adju
ti tight ghten en th the e adj
bri bring ng the the ri ring gear
(2) When (2) When the backlash the backlash is is insuff
Loosen the adjusting nut of the rear side of the ring gear Loosen the adjusting nut of the rear side of the ring gear
and ti and tighte ghten n the adju
to bring the to bri ng the ri ring gear away from
7. Tighten en the adjusti 7. Tight
fur furthe ther r by by 1.5
8. Instal 8. Install the adjusting l the adjusting nut loc
9. Final 9. Finally tigh ly tighten
T T
= 11 = 117. 7.7 -
[86.82 [86. 82 - - 10
[Point 4] [Point 4]
Reassembly: Reassembly:
Appl Apply y seal sealing ing agent (08826-
of the he dif of t differ ferent
Reassembly: Reassembly:
Coat thread tightener Coat t hread tightener (08833-0008
rier rier set bolt set bolts s before tight
https://www.besttruckmanuals.com/
not satisf satisfied, ied, adjust adjust by by turni
erenti ntial al case ASSY case ASSY in in the thr
excessiv sive: e:
the adjusti sting ng nut o nut on t n the he ri ring gear teet
adjust ustin ing g nut o nut on the n the re rear sid
ng gear clo closer ser to th to the e dri
insufficie icient: nt:
the adjusti sting ng nut on nut on the tee
ng gear away from the driv
the adjusting ng nut nut on the rear side of t on the rear side of the he ring gear
1.5 to 2 notche to 2 notches. s.
nut lock plate. k plate.
ten the beari the bearing ng cap set cap set bolt
7 - 13 137. 7.3 3 N· N·m m (1 (120 200 0 - - 14 1400 kg
101. 1.3 ft-Ibf] 3 ft-Ibf]
agent (08826-00090 00090) ) on t
ential ial car carri rier er and and housi housing ng befo
(08833-00080) 0) on on the di
before tightening ening it. it.
turning ng the adjust- the adjust-
the thrust ust di- di-
ng gear teeth h sid side e and and
ar side e as much as much to to
drive ve pin pinion ion. .
the teeth th sid side e as much as much
the drive e pin pinion. ion.
ring gear
bolts. s.
00 kg f-cm) f-cm)
on the mating surfac he mating surfaces es
before re rea reassembl ssembly. y.
the differ fferential ential car- car-
3-19 3-19