Toyota 7FG 10 Repair Manual page 76

Measur Mea sure e the for the forwar
Standard: 0.1 Standard:
[Point [P oint 7 7 ] ]
Disassembly: Disassembly:
SST 09420-23000-71 SST 09420-23000-71
Reassembly: Reassembly:
Pre Press ss in in aft after er mat
with h the shaft wit the shaft spl
SST 09608-04031 SST 09608-04031
[Point [P oint 8] 8]
Inspection: Inspection:
Measure re the c Measu the counte
1st gear r . re 1st gea . reve
Limit: 29.9 mm (1.177 in) Limit: 29.9 mm (1.177 in)
2nd gea 2n d gear· r· forwa
Limit: 39.9 mm (1.571 in) Limit: 39.9 mm (1.571 in)
Inspection: Inspection:
Measur Mea sure e the insi the inside
1st gear r . re 1st gea . reve
Limit: 38.1 mm (1.500 in) Limit: 38.1 mm (1.500 in)
2n 2nd d ge gear ar· · forwa
Limit: 48.1 mm (1.894 in) Limit: 48.1 mm (1.894 in)
https://www.besttruckmanuals.com/
[P [Point oint 9] 9]
ward d gea gear r thr thrust ust cle cleara
0.15 .... 5 .... 0 .4 0.40 0 mm mm (0. (0.005 0059 9 ... .... . 0 .0
matchi ching ng the cham the chamfer fered
spline ine inl inlet. et.
ountersha rshaft ft journ journal al outsi outside
verse rse ge gear ar: :
forward rd ge gea a r: r:
de dia diamet meter er of e of each ach gea
verse rse ge gear ar: :
forward rd ge gear ar: :
arance nce. .
0.0157 157 in) in)
ed sid side e of hub spl of hub spline ine
de diame diameter. ter.
2-21 2-21
gear. r.