Toyota 7FG 10 Repair Manual page 93

1. 1. Whi While le sup suppor
rear bear rear bearing, washer
face e the dee fac the deep p gro
2. Use the input shaft t to preve 2. Use the input shaf
3. Tighte 3. Tig hten n the
4. Measu 4. Measure re the driv
Standard: Standard:
8.8 8.82 - 2 - 13.
[6.51 - [6. 51 - 9.7
If t If the he st stan
cre crease the shi ase the shim m thi
Shim thickness: Shim thickness:
0.1 0.13, 3, 0.1,
5. Secu 5. Securel rely y loc
[Po [Point int 6] 6]
Disassembly: Disassembly:
SST 09420-23000-71 SST 09420-23000-71
Reassembly: Reassembly:
Insta Install the ll the drive pinion front drive pinion front beari
1. 1. Use the SST for front Use the SST for front beari
SST 09316-60011 SST 09316-60011
[Point [Po int 7] 7]
Reassembly: Reassembly:
Ch Chec eck k th the e mo
ducti duction on gear. gear.
https://www.besttruckmanuals.com/
Reassembly: Reassembly:
Apply sealing Apply sealing agent
portin ting g the dri the drive ve pin pinion ion, , ass
ing, washer and lock nut. The washer claw shall and lock nut. The washer claw shall
groove ove sid side. e.
to prevent nt the gear the gear fro
the loc lock k nut to th nut to the e spe specif cified ied tor
the drive e pinio pinion n start starting ing torqu
13.23 23 N·m N·m (90 (90 - - 135 135 kgf kgf-cm
9.77 7 ft- ft-Ibf Ibf] ]
anda dard rd is is no not t sa sati tisf sfie ied, d, in incr crea
thickne ckness ss for adjust
0.1, 0.1 0.15, 5, 0.3 0.35 an 5 and 0.4 mm d 0.4 mm
lock the k the loc lock k nut nut. .
bearing. ng.
bearing ng inst installat
moun unti ting ng di dire rect ctio ions ns of th of the e ou
agent (Three (Three Bond Bond No.
assemb emble le the shim the shim, ,
from m rot rotati ation. on.
torque que. .
torque. e.
-cm) )
ease se or de- or de-
for adjustmen ment. t.
allation. ion.
outp tput ut ge gear ar an and d re re- -
3-15 3-15
No. 1281 1281 or or equivalent) equivalent)