Toyota 7FG 10 Repair Manual page 68

[Po [Point int 3-4
Disassembly·Reassembly: Disassembly·Reassembly:
Lock the output shaf Lock t
inst install alling
Reassembly: Reassembly:
Good example Good example
Aft After tight er tightening
securely ly (in secure
~ ~
~ ~
Bad example Bad example
~ ~
~ ~
[Po [Point int 5] 5]
Reassembly: Reassembly:
Install by ali Inst
the groove on each the groove
rubber boot on the link side beforehand. rubber boot on the link side beforehand.
[Point [Po int 6] 6]
Inspection: Inspection:
In Insp spec
any exce an y excess
seal. seal.
Removal: Removal:
Use a sc Use a screw
Reassembly: Reassembly:
SST 09370-10410-71 SST 09370-10410-71
Apply Apply MP
seal before reass seal before
[Po [Point int 7] 7]
Inspection: Inspection:
https://www.besttruckmanuals.com/
In Insp spec
an any y ex
3-4] ]
he output shaft with a pip t with a pipe wrenc
ing the count the countershaf ershaft t or out or output
ening each each lock nut lock nut to t
(in two places two places each). each).
all by alignin gning g the ti the tip p end end of t
on each shif shift fork t fork shaf
ect t th the e ou outp tput ut sh shaf aft t oi oil se l seal al li lip f
ssiv ive e we wear ar or da or dama mage
rewdri driver ver and brass and brass bar for remo
MP grease grease on on the the outer outer periphery
reassembly embly. .
ect t th the e ou outp tput ut sh shaf aft t oi oil se l seal al li lip fo
exce cess ssiv ive e we wear ar or da or dama mage
e wrench h when when removi removing ng or
put shaf shaft t lock nut. lock nut.
to the speci he specifi fied ed torq torque, ue, lock it lock it
of the he FIR or FIR or shift link with shift link with
1 1 1 1 2 2
shaft for assembly. t for assembly. Inst Install the all the
p for wea or wear r or dam or damag age. e. If If
ge is f is fou ound nd, , re repl plac ace e th the e oi oil l
bar for removal val. .
periphery and and lip lip of of the
p for r we wear ar or dam or damag age. e. If If
ge is is fo foun und, d, re repl plac ace e th the e oi oil l
or
2-13 2-13
the oil oil