Toyota 7FG 10 Repair Manual page 91

Match Match mark marks s
Rem Remove ove the the loc
1. Un 1. Unloc lock k the the loc
2. Inst 2. Install the all the inp
gear from gear from rotat
3. Remov 3. Remove e the
[Point 2] [Point 2]
Reassembly: Reassembly:
Apply Apply sealing sealing agent
the different the diff erential
ential l housi entia housing.
[Point 3] [Point 3]
Inspection: Inspection:
Measure re the ring gear Measu the ring gear backl
Standard: Sta ndard: 0. 0.2 -
[Point 4] [Point 4]
Disassembly: Disassembly:
provid pro vide e mat match
housing. housing.
Reassembly: Reassembly:
Instal Ins tall l the the adj adjust
1. 1. Insta Install the ll the adju
2. Instal 2. Ins tall l the beari the bearing
tem tempor porari arily ly tig
= 1 = 19. 9.6 6 N· N·m m (2 (200 kg
T T
3. Set a dial gauge in in the 3. Set a dial gauge
case. case.
https://www.besttruckmanuals.com/
4. Use the SS 4. Use the
lock k nut nut, was , washer her, , rea rear r bea bearin
lock k nut nut. .
input shaft ut shaft and use a pip and use a pipe wrenc
rotation. ion.
the loc lock k nut an nut and washe d washer. r.
agent (Three (Three Bond Bond 1217C 1217C or or equivalent)
ial cover surfa cover surface ce to be in to be in conta
ng.
backlash. ash.
2 - 0. 0.3 mm 3 mm (0 (0.0 .008 - 08 - 0. 0.01
ch mar marks ks on t on the beari he bearing ng cap and
usting ing nut an nut and beari d bearing ng cap
adjusting sting nut. nut.
ng cap by cap by ali aligni gning ng the match
tighte hten n the set bo the set bolts lts. .
00 kg f-cm) f-cm) [14. [14.5 5 ft-I
the thr thrust ust dir direct ection
SST T an and tig d tight hten en un unti til the thr l the thrus
ring g rol roller and ler and shi shim. m.
e wrench h to lock the to lock the
equivalent) on on
contact ct with the differ with the differ- -
012 2 in) in)
cap and dif differ ferent ential ial
cap. .
the match mar marks ks and and
ft-Ibf] bf]
3-13 3-13
ion of the diffe of the differen rentia tial l
ust t cl clea eara ranc nce e is is