Gree FP-22LM/D-K Owner's Manual page 20

Vertical Exposed Fan Coil Unit
Parameter list:
S.N
01 Power failure memory
02 Energy saving function
03 Drying function
04 Temperature unit setting
Fan operation at temperature
05
set points
06 Temperature calibration
07 Temperature control range
Cooling temperature set in the
08
energy saving mode
Heating temperature set in the
09
energy saving mode
10 Ambient temperature display
11 Factory data reset
Below are instructions for setting the parameters.
(1) Power failure memory
When the function is enabled, if a power failure occurs while the unit is working or stopped, the last
screen of data that was collected will be displayed upon restoration of power.
When the function is disabled, if a power failure occurred while the unit was stopped, it will automatically
restart with a unit stop display when power is restored.
As shown in the Figure 7 (the function has been disabled), on the parameter setting page, press
(MODE) to switch the option number to 01.
ON and OFF (—enable or disable the function).
Name
ON: enable (by default); OFF: disable
ON: enable; OFF: disable (by default)
ON: enable; OFF: disable (by default)
F: Fahrenheit; C: Celsius (by default)
00: the fan works as to the set speed;
01: the fan works at the low speed;
02: the fan stops (by default)
Adjustable range: -5°C~+5°C (a precision of 0.5°C, 0°C by default)
1: narrow ; 2: medium (by default); 3: wide
Adjustable range: 16°C~30°C (a precision of 0.5°C, 16°C by
default);
When the temperature unit is Fahrenheit, the adjustment range of
the temperature is 61°F~86°F (a precision of 1°F).
Adjustable range: 16°C~30°C (a precision of 0.5°C, 30°C by
default);
When the temperature unit is Fahrenheit, the adjustment range of
the temperature is 61°F~86°F (a precision of 1°F).
ON: enable; OFF: disable (by default)
ON: enable; OFF: disable (by default)
Description
(UP) or (DOWN) is provided to allow a switch between
Figure 7
17