Replacement Of Blade Engaging Cable; Replacement Of The Throttle Lever - Honda HF2213 Shop Manual

6.9

Replacement of blade engaging cable

1. Remove the collecting conveyor (see 5.3).
2. Remove the upper protection cover where fitted.
3. Place the cutting plate in the lowest position and set the
blade lever to the disengaged position. Then, loosen the
tightener [1], remove it from its seat and unhook the
spring [ 2].
4. Remove the end of the cable [3] from the fork [4] located
on the lever hinge and remove the cable [5].
5. After reinstalling the cable, adjust the engagement of the
blades (see 4.1).
6.10 Replacing the throttle lever
1. Detach the end of the cable from its cable stop on the
engine side.
2. Using a socket wrench inserted in the cable passage slot,
undo the two fixing screws [1] and remove the accelerator
together with the cable.
104