Console Ports - Cisco Catalyst IE9300 Hardware Installation Manual

Cisco IE9300 Rugged Series Overview
Color
SNMP trap
External
Table 7: Alarm Input LEDs
Color
Off
Green
Red
Blinking red
Table 8: Alarm Output LEDs
Color
Green
Red
Blinking red

Console Ports

The Cisco Catalyst IE9300 Rugged Series Switch has two console ports: one RS-232 port with an RJ-45
connector, and one USB port with a micro-USB connector. The USB port is behind a small door on the front
panel.
Output from the switch is always sent to both ports, but input is accepted only from one port at a time. The
USB console LED shows which console port is in use. If both RS-232 and USB console ports are connected,
the USB console port has priority unless you disable the USB console.
Status
Configure the SNMP traps on the switch to send the notification to the SNMP
server.
Configure the switch to trigger an external alarm device by using the alarm relay.
Status
Alarm is not configured.
Alarm is configured but no alarm detected.
Minor alarm is present.
Major alarm is present.
Status
Alarm is not present.
Minor alarm condition is present.
Major alarm condition is present.
Cisco Catalyst IE9300 Rugged Series Switch Hardware Installation Guide
Console Ports
9