Attach Wall-Mount Brackets - Cisco Catalyst IE9300 Hardware Installation Manual

Switch Installation
Switch
IE9310 GE Fiber
IE9320 GE Fiber
IE9320 GE Fiber
Warning
The following minimum clearances apply when mounting the switch vertically in an enclosure:
• Sides of switch (facing up and facing down): 3.75 in (9.52 cm)
• Port side 3.0 in (7.62 cm)
• Power supply side: 5.25 in (13.33 cm)
• Cover side (not facing wall): 1.75 in (4.44 cm)
• Base side (facing wall): 0 in (0 cm)

Attach Wall-Mount Brackets

Attach the brackets to the switch so that you can attach it to a wall.
Attach the switch to the wall, as shown in the following illustration:
For mounting railway-application equipment and for EN50155 standard compliance, the switch must
be installed only in a rack mid-mounting position. If you install the switch in a front rack-mounting
(cable side or power supply side) position or in a wall-mounting position, a mechanical failure can occur
that results in the switch becoming detached from the rack. (Statement 403)
Cisco Catalyst IE9300 Rugged Series Switch Hardware Installation Guide
Wall Gap
Flush
0.75 in
Flush
Attach Wall-Mount Brackets
Temperature Derating
No derating
No derating
5° C derating
27