Cisco Catalyst IE9300 Hardware Installation Manual page 69

Switch Configuration with the CLI Setup Program
interface GigabitEthernet1/0/27
!
interface GigabitEthernet1/0/28
!
interface AppGigabitEthernet1/0/1
!
end
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Building configuration...
[OK]
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
What to do next
After you complete the setup program, the switch can run the default configuration that you created. If you
want to change this configuration or want to perform other management tasks, you can do so through the CLI.
To use the CLI, enter commands at the Switch > prompt through the console port by using a terminal emulation
program or through the network by using Telnet. For configuration information, see the switch software
configuration guides on Cisco.com.
Cisco Catalyst IE9300 Rugged Series Switch Hardware Installation Guide
Complete the Setup Program
61