Removing And Replacing A 4-Bay Lff Drive Backplane - HP HPE ProLiant DL180 Gen10 Maintenance And Service Manual

To replace the component, reverse the removal procedure.

Removing and replacing a 4-bay LFF drive backplane

Procedure
1. If installed, remove the bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
5. Remove the access panel.
6. Remove the air baffle.
7. Remove all fan modules.
8. Remove all installed LFF drives.
9. Disconnect all cables from the 4-bay LFF drive backplane.
10. Remove the drive backplane.
Removal and replacement procedures 73