Removing And Replacing The Optical Drive From The Sff Chassis - HP ProLiant DL20 Gen10 Plus Maintenance And Service Manual

Removing and replacing the optical drive from the SFF chassis

Removing and replacing the optical drive from the SFF chassis
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated CAUTION:
with either a component or a blank.
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure Procedure
1. If installed, remove the front bezel .
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Disconnect the SATA-power Y-cable from the optical drive .
9. Remove the optical drive cage assembly from the media bay.
Retain all screws for future use.
10. Remove the optical drive from the cage.
Retain the screw for future use.
Removing and replacing the optical drive from the SFF chassis 88