HP ProLiant DL20 Gen10 Plus Maintenance And Service Manual page 167

8. Install all the components removed from the failed system board.
9. Install the M.2 air baffle.
10. Install the processor air baffle.
11. Install the access panel.
12. Install the inner rails.
13. Install the server into the rack.
14. Connect all peripheral cables to the server.
15. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
16. Power up the server .
17. If removed, install the front bezel.
18. Ensure all firmware, including option cards and embedded devices, is updated to the same versions to ensure that the latest drivers
are being used.
19. Re-enter any Secure Boot Keys that were previously added in the Secure Boot configuration.
20. Re-entering the server serial number and product ID .
Installing the system board 167