Remove The Chassis Ear - HP ProLiant DL20 Gen10 Plus Maintenance And Service Manual

Remove the chassis ear

Remove the chassis ear
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure Procedure
1. If physically powering down a server with the front bezel installed, remove the front bezel .
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove all inner rails from the chassis.
Retain all rails for future use.
8. Remove the chassis ears:
a. Remove all screws (callout 1).
Retain all screws for future use.
b. Disengage the right ear from the chassis (callout 2).
Thumbscrew ears
Remove the chassis ear 60