Remove The Riser Cage - HP ProLiant DL20 Gen10 Plus Maintenance And Service Manual

Remove the riser cage

Remove the riser cage
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the WARNING:
internal system components to cool before touching them.
Procedure Procedure
1. If physically powering down a server with the front bezel installed, remove the front bezel .
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. If an expansion card with internal cables is installed on the riser, disconnect the cables from the card.
9. Lift the riser cage off the system board.
Remove the riser cage 66