Table Of Contents - Yetter GERMINATE UNIFORMITY 2940 Operator's Manual

Bolt Torque........................................................................................2
Safety...............................................................................................4
Hydraulic Fittings Chart........................................................................5
Components, Kits, and Part Numbers.................................................6 - 9
Introduction & System Requirements........................................................10
System Information..................................................................................11 - 15
Installation Guide........................................................................16 - 19
Residue Manager Installation..................................................................20 - 22
Residue Manager/Coulter Combo Installation..........................................23
Tablet Mount / Power Harness ....................................................................24
2940-103A Control Box Installation........................................................25
2940-415 Water Separator/Regulator Assembly Installation.........................25
ISOBUS Installation.........................................................................................26
Yetter Compressor Installation............................................................27 - 30
Compressor to Control Box Airline Installation..................................31 - 32
Airline Installation.....................................................................................32 - 47
Operation.................................................................................48 - 54
Maintenance..............................................................................55 - 56
Parts Identification........................................................................57 - 78
Troubleshooting.............................................................................................. 79
Regularly inspect each residue manager for loose or worn bolts & hardware. Repair or replace as needed.
All hardware used on the 2940 Air Adjust is Grade 5 unless otherwise noted. Grade 5 cap screws are marked with
three radial lines on the head. If hardware must be replaced, be sure to replace it with hardware of equal size,
strength and thread type. Refer to the torque values chart when tightening hardware.
Important: Over tightening hardware can cause as much damage as when under tightening. Tightening
hardware beyond the recommended range can reduce its shock load capacity.
The chart below is a guide for proper torque. Use it unless a specified torque is called out elsewhere in the
manual. Torque is the force you apply to the wrench handle or the cheater bar, times the length of the handle
or bar. Use a torque wrench whenever possible.
2

TABLE OF CONTENTS

BOLT TORQUE