Touareg 2010 ➤
Brake systems - Edition 05.2011
9
Repairing brake lines
The flanging tool for brake lines -VAS 6056- can be used to flange
brake lines with an outer pipe diameter of 5 mm without damaging
the coating. In certain cases, this allows sections of brake lines
to be renewed at less expense.
The use of flanging tool V.A.G. 1356 is not permitted due to the
coating and the diameter of the black brake lines.
Note
Brake lines may only be bent to max. 90°, as they otherwise
♦
kink or display deformations which constrict the cross-section
of the line to an impermissible degree.
Preferably separate brake lines at vehicle floor.
♦
The positions of the intermediate pieces must be selected so
♦
that they cannot chafe on moving parts.
Do not grease spindle; merely clean with methylated spirits.
♦
Special tools and workshop equipment required
♦ Flanging tool for brake lines -VAS 6056-
♦ Brake filling and bleeding equipment -VAS 5234-
List of individual tools:
Item
Tool
1
Flanging tool (incl. flanging jaws
VAS 6056/6)
2
Pipe cutter
3
Brake line scraper
4
Set of grips with plastic jaws
5
Pipe bending tool
6
Special wrench, 6 mm
7
Flanging jaws
1) Grub screws (in shaft and at side) are adjusted and must not be readjusted!
102
Rep. gr.47 - Brakes - hydraulics
Tool number
VAS 6056/1
VAS 6056/2
VAS 6056/3
1)
VAS 6056/4
VAS 6056/5
VAS 6056/7
-