Program Comments - HP 83751A Programming Manual

5. Prom the front panel, attempt to change the start frequency and verify
6. Verify that all keys except (LOCAL] are disabled.
7.
8. Execute a 'continue" on the controller. With the controller displaying
9. Attempt to change the start frequency and press (PRESET). Verify that
10. Now press the sweeper CZXTI) key and verify that still no action is
11. Execute a "continue" on the controller. With the controller displaying
Note that the sweeper @ZiT) key produces the same resuh as programming LOCAL 719 or LOCAL
7. Be careful because the LOCAL 7 command places all instruments on the HP-IB in the local state as
opposed to just the sweeper.

Program Comments

90 to 120:
130:
140:
150
200:
210 to 230:
that this is impossible.
Now press the [LOCAL) key and verify that the sweeper REMOTE LED is
off and that you can modify any of the sweep functions.
"LOCAL LOCKOUT mode", verify that the sweeper REMOTE LED is again
lit.
this is impossible.
taken.
"LOCAL mode", verify that the sweeper REMOTE LED is off. Also verify
that all sweep functions now can be modiiied via the front panel controls.
Print a message on the computer's display, then pause.
Place the source into REMOTE.
Place the source into LOCAL LOCKOUT mode.
to 190: Print a message on the computer's display, then pause.
Return the source to local control.
Print a message on the computer's display.
Getting Started Programming
Programming Typical Measurements