The Standard Operation Status Group - HP 83751A Programming Manual

The Standard Operation
The Standard Operation status group is used to determine the specific
Status Group
condition that set bit 7 in the Status Byte. The Standard Operation status
group consists of the Operation Condition register, Operation Negative
Transition register, Operation Positive Transition register, Operation Event
register, and Operation Event Enable register. The bits in the Operation
Event register provide you with the following information:
Bit
0
1
2
3
4 to 7
8
9
10
11 to 15
Description
1 in this bit position indicates that a calibration is being
performed (auto tracking, power meter Cal, YIG oscillator cal).
1 in this bit position indicates that the synthesized sweeper
hardware is settling (for example, the power level is changing).
This bit is always set to 0.
1 in this bit position indicates that the synthesized sweeper is
sweeping (in the process of completing a sweep).
These bits are always set to 0.
1 in this bit position indicates that the synthesized sweeper
self-test data is ready.
1 in this bit position indicates that the synthesized sweeper's
has
display changed.
1 in this bit position indicates that the synthesized sweeper
self-test is in progress.
These bits are always set to 0.
Getting Started Programming
Programming the Status System