Table of Contents
Advertisement
Intesis MAPS: Configuration and Monitoring Tool
IMPORTANT
This function is only available for the 700 Series platform.
12.2.4. Configuration Tab
In the Configuration tab, you can configure general parameters and parameters for both protocol interfaces of
the Intesis gateway.
On the left side of the window, three submenus are shown:
• Submenu 1: General configuration parameters for the gateway.
• Submenus 2 and 3: BMS and Device respective protocols configuration parameters.
12.2.5. Signals Tab
This menu lists all available signals and parameters for both protocols.
NOTE
You can find more information on every parameter and how to configure it in the Intesis MAPS user
manual.
12.2.6. Receive/Send Tab
Send
Once you have finished setting the parameters, you have to send the configuration to the gateway.
Follow these steps:
1.
Click the Send button.
a.
If the gateway is still factory-set, you will be prompted to save the project on your PC. Once you save it,
the configuration is automatically sent to the gateway.
b.
If you have already saved the project, the configuration is automatically sent to the gateway.
2.
Connect again with the gateway after sending the file.
NOTICE
The gateway will reboot automatically once the new configuration is loaded. This process may
take a few seconds.
Receive
Use this function to get the configuration of a gateway, for example, when you need to change some parameters
of a gateway already mounted in an installation.
Once the configuration is completed and sent, the gateway is already operative. Even so, you should check that
everything is working correctly by entering the Diagnostic tab.
USER MANUAL Version 1.0
IN700-485 Series
Page 31 of 36
Advertisement
Table of Contents
