IN700-485 Series
12.2.2. Template Selection
When opening the software, you will see the main window, called Getting started. Here you can select the
template for your application:
1.
Click Create New Project in the left menu.
2.
Select the appropriate template for your application. To filter the selection:
• Click on the protocol logos.
• Type the order code in the Order Code field,
• Check out the list to find the template you need.
3.
Select the template and click Next or double-click it in the list.
12.2.3. Connection Tab
1.
On the Connection Type parameter select the way you connected the gateway to your PC:
• Select IP if you are using the Ethernet port of the Intesis gateway.
IMPORTANT
Make sure you have an internet connection.
NOTE
When using IP connection, the device's name is listed in black if it's compatible with the
selected template and red if it's not.
• Select USB Port if you are using the Console port of the gateway.
2.
Select your gateway from the Discovered Gateways list on the left.
3.
Click Connect.
NOTE
If your Intesis gateway firmware doesn't match the selected template, a pop-up window will prompt
you to upload the correct firmware.
Page 30 of 36
Figure 7. The three possibilities for the template selection
Intesis MAPS: Configuration and Monitoring Tool
USER MANUAL Version 1.0