Table of Contents
Advertisement
STARTING AND STOPPING THE DRYWALL SANDER
Make sure power circuit voltage is the same as shown on the specification plate on the Sander, and
that the Sander switch is OFF. Connect Sander to power circuit.
The Drywall Sander is equipped with a qualified switch with a lock block. Depress the switch, not
loosen your hand, this machine will be "ON", if press the lock block, machine will be on even your
hand leave the switch.
Re-press the switch, the switch will be stopped.
SANDING WHEEL SPEED REGULATION
The Drywall Sander is equipped with variable speed control. The speed is adjusted by turning the
control knob. The control knob goes from "MIN" to "MAX" from the slowest speed to the fastest
speed).
Use the higher speed settings for fast removal of the exceeding. Use the lower speed settings to
reduce the removal rate to have more precise control.
Advertisement
Table of Contents
